Home > News > Content

Rebar Threading Machine Always Lubricate Maintenance

May 18, 2017

Rebar Threading Machine Simply said, need to rely on friction brake components, such as bite line beads folder and brakes the turntable, are prohibited from the oil, these are "touch the oil that is destroyed" place, must be careful to keep dry and clean, only Some frequent rolling / sliding place, such as beads inside the beads with the teeth, etc., is the need for regular lubrication maintenance, in addition to the formation of oil film can be isolated from the air, to prevent rust, the lubrication after the damping smaller, Rebar Threading Machine feel more smooth, pounds The number will be more accurate. Another point, lubrication may not necessarily oil, you can also use graphite powder, like we can not open the lock, will be cut in the pencil above the pencil is not poured into the same keyhole, in fact, that is the use of graphite lubrication, Can also be treated like this,Rebar Threading Machine the advantage is that this solid lubricant is not easy to do oil everywhere, affecting threading, the disadvantage is that the surface adhesion is relatively weak, relatively smooth lubrication, the duration is not long enough. While the sewing machine oil and bicycle oil and other traditional oil although easy to purchase, but relative to the threading machine this machine is a bit too "light", and is not easy to form a solid oil film, while the impurities a little bit big,Rebar Threading Machine I heard that the United States With firearms dedicated oil to maintain the threading machine, it touches a little to kill the chicken with a chopper, but do it is also a good thing. Oil, then recommend WD-40 spray-type lubricant, no impurities, but also to achieve the melting of impurities to clean the interface, and the formation of oil film protection and other functions, followed by a needle to absorb the trace of WD40 re-injection to the beads inside,Rebar Threading Machine Instead of pencil gray, but also found very easy to use, but must control the amount of good, or get into the line, and then dip to the face up, then, is still in front of that advice: "hit the oil that is destroyed."

Do not want to do those out of the domestic market to sell the kind of three or four lines, because the sewing needle these parts are high-speed round-trip, so the performance requirements of lubrication is also very high, with this oil to lubricate the threading machine certainly no problem. The location of some other bearings,Rebar Threading Machine as well as fixed under the track track, there are outside the closure was better, not easy to meet the ball ball beads beads and beads, suitable for butter, than the graphite powder and wd40 are good,Rebar Threading Machine Another wd40 the most important role is to rust clean, on the basis of this to achieve the lubrication, you get a little wd40 rub in the hand, rub a few times on the astringent feeling, this for a long time to use, no Rust affected parts, it is not suitable. For some stainless steel parts, there is no rust problem, so you can not consider wd40, in this case with anhydrous alcohol is the best choice, medical alcohol is generally about 75%, which contains a lot of water, Maintenance is not good.