Home > News > Content

Rebar Threading Machine Need Regular Lubrication Maintenance

Jul 17, 2017

There are many aspects of the maintenance of Rebar Rebar Threading Machine, and today we first talk about the contents of cleaning up the clip. Usually in the clean-up clip will be used when the alcohol and toothbrush will brush about, this approach is usually the most commonly used method, but also the most simple way, but to make the clip life longer life, better Use, then it is necessary to thoroughly clean the clip. Here we explain in detail how to completely clean up the clip.

Need to prepare the tools: sewing machine oil, industrial alcohol (also known as: anhydrous alcohol), rust agent, medical gauze, soft brush, toothbrush, line cones, cone, cotton swab, butter.

How should the Rebar Rebar Threading Machine be maintained and oiled? Sewing machine does not work? What places can be added where can not increase?

Simply said, need to rely on friction brake components, such as bite line beads folder and brakes the turntable, are prohibited from the oil, these are "touch the oil that is destroyed" place, must be careful to keep dry and clean, only Some frequent rolling / sliding place, such as beads inside the beads with the teeth, etc., is the need for regular lubrication maintenance, in addition to the formation of oil film can be isolated from the air, to prevent rust, the lubrication after the damping smaller, feel more smooth, pounds The number will be more accurate. Another point, lubrication may not necessarily oil, you can also use graphite powder, like we can not open the lock, will be cut in the pencil above the pencil is not poured into the same keyhole, in fact, that is the use of graphite lubrication, Can also be treated like this, the advantage is that this solid lubricant is not easy to do oil everywhere, affecting threading, the disadvantage is that the surface adhesion is relatively weak, relatively smooth lubrication, the duration is not long enough. While the sewing machine oil and bicycle oil and other traditional oil although easy to purchase, but relative to the Rebar Rebar Threading Machine this machine is a bit too "light", and is not easy to form a solid oil film, while the impurities a little bit big, I heard that the United States With firearms dedicated oil to maintain the Rebar Rebar Threading Machine, it touches a little to kill the chicken with a chopper, but do it is also a good thing. Oil, then recommended spray-type lubricant, no impurities, but also to achieve the melting of impurities to clean the interface, and the formation of oil film protection and other functions, followed by a needle to attract a small amount of re-injection to the beads inside to replace the pencil gray, Also found very easy to use, but must control the amount of good, or stained line, and then stained to the face up, then, is still in front of that advice: "hit the oil that is destroyed."

Behind the master with the wood to meet the communication, he felt sewing machine oil is a good thing, but to slightly better, do not let those casually out of the domestic market to sell the kind of three or four lines, because the sewing needle these parts are high-speed round trip, So the performance requirements of lubrication is also very high, with this oil to lubricate the Rebar Rebar Threading Machine certainly no problem. The location of some other bearings, as well as fixed seat track below the track, there are outside the closure was better, not easy to meet the ball ball beads beads and beads, suitable for butter, better than the graphite powder, the other The most important role is to rust clean, on the basis of this to achieve the lubrication, you get a little rub in the hand, rubbing a few times on the astringent feeling, this need for a long time to use, no rust Parts, it is not suitable. For some stainless steel parts, there is no rust problem, so you can not consider, in this case with anhydrous alcohol is the best choice, medical alcohol is generally about 75%, which contains a lot of water, Not very good.